SAMAYAसमय

Size guide

Reference 01 is 39 mm across and 46.8 mm from lug to lug. Measure your wrist, check the table, or print the case at actual size and hold it on your arm.

Measure your wrist

  1. Cut a strip of paper

    About 1 cm wide and 25 cm long. A tailor's tape measure works too.

  2. Wrap it where you wear a watch

    Just above the wrist bone, snug but not tight.

  3. Mark where it overlaps

    Or pinch the spot between finger and thumb.

  4. Measure it flat

    From the end of the strip to the mark, in centimetres. That is your wrist size.

The numbers that decide the fit

Across the case
39.0 mm
Lug to lug
46.8 mm
Thickness
10.4 mm, crystal to caseback
Strap
20 mm at the lugs, 18 mm at the buckle

How it fits your wrist

A watch sits best when its lugs end inside the flat top of your wrist, which is about a third of the way round. This table uses that rule of thumb.

Flat top: your wrist size divided by 3.1. A guide, not a measurement; the paper template settles it.
Your wristFlat top, aboutHow Reference 01 sitsStrap
14 cm5.5 in45 mmWide: the lugs pass the edgesShort
15 cm5.9 in48 mmClose: the lugs reach the edgesStandard
16 cm6.3 in52 mmGood: the lugs end insideStandard
17 cm6.7 in55 mmGood: the lugs end insideStandard
18 cm7.1 in58 mmGood: the lugs end insideStandard
19 cm7.5 in61 mmGood: the lugs end insideStandard
20 cm7.9 in65 mmGood: the lugs end insideLong
21 cm8.3 in68 mmGood: the lugs end insideLong

Between two sizes? Print the template below. Ten seconds on your wrist tells you more than any table.

Strap lengths

All three cost the same. We fit the standard length unless you ask for short or long when we call to confirm your order.

  • Short

    Wrists 13.5 to 16.5 cm

    65 mm and 105 mm long, buckle end first.

  • Standard

    Wrists 15 to 19 cm

    70 mm and 115 mm long, buckle end first.

    Fitted unless you ask for another length.

  • Long

    Wrists 17.5 to 21.5 cm

    80 mm and 130 mm long, buckle end first.

Print it at actual size

The drawing is made from the watch's own geometry, so on paper it is exactly the size of the real case.

  1. Print at 100%

    In the print settings choose “Actual size” or a scale of 100%, not “Fit to page”.

  2. Check the scale

    Measure the line under the drawing. It should be exactly 50 mm. If it is not, print again at 100%.

  3. Cut it out

    Cut around the case and the lugs.

  4. Hold it on your wrist

    Where you wear a watch, in front of a mirror. The lugs should end inside the flat top of your wrist.

Reference 01, actual size

39.0 20.0 between lugs 46.8
01020304050
This line is 50 mm long when printed at 100%.

Cut around the case and the lugs. On screen the size may differ; on paper at 100% it is exact.